Table 20: Interface Status Diagnostic Field Descriptions - Motorola DCX3520e-M Installation Manual

Diagnostics

Table 20: Interface Status Diagnostic Field Descriptions

Field Description
DOCSIS Tuner & Indicates if enabled; indicates if active.
Xmitter
USB I/O Device Indicates if enabled; indicates if active.
Ethernet Device Indicates if enabled; indicates if active.
Parallel Port Indicates if enabled; indicates if active.
IR Xmit Indicates if enabled; indicates if active.
Hard Drive Indicates if enabled; indicates if active.
Status
Smart Card Indicates if enabled; indicates if active.
HDMI Port If a device is connected to the HDMI port only, the following diagnostics display to
help troubleshoot the HDMI interface. They all display "N/A" if no device is connected
to the HDMI port, or if the value is invalid or cannot be retrieved.
Audio will indicate the type of audio, for example PCM, Dolby Digital (for AC3), Dolby
Digital Plus, DTS, or AAC. Audio rate is displayed in KHz as one of the following
values: 32, 44.1, 48 and 96 kHz
•
•
•
•
•
Aspect Ratio — Indicates the aspect ratio of the video sent through HDMI —
4:3 or 16:9.
EDID Data
Indicates the video timing formats that were read from the Extended Display
Identification Data (EDID) register for the connected device, in particular the detailed
timing description blocks. The list displays all of the formats that the DCX3520e-M
could read, up to a maximum of eight formats. If the DCX3520e-M cannot read any
formats, EDID Data is blank. An asterisk (*) after the aspect ratio means the
DCX3520e-M supports the format. If more than twelve video timing formats are
discovered, the supported formats only are listed first, followed by up to twelve
remaining formats.
High-Definition DVR DCX3520e-M • Installation Manual
365-095-22819-x.1
Device Connected — Indicates whether a device is connected to the HDMI port—
Yes or No.
Repeater — Indicates whether the connected device is a repeater — Yes or No.
Video Xmission (transmission) — Indicates whether the DCX3520e-M is transmitting
video over the HDMI port — Not Active or Active.
HDCP Enabled — Indicates whether the DCX3520e-M is using HDCP to encrypt
video transmitted over the HDMI link — Yes or No. If the Video Xmission status is
Not Active, the HDCP Enabled status is No.
Output Format — Indicates the timing format of the video sent through HDMI:
1920 x 1080i — 1920 pixels wide by 1080 pixels high, interlaced
o
1280 x 720p — 1280 pixels wide by 720 pixels high, progressive
o
720 x 480p — 720 pixels wide by 480 pixels high, progressive
o
720 x 480i — 720 pixels wide by 480 pixels high, interlaced
o
640 x 480p — 640 pixels wide by 480 pixels high, progressive
o
B
76