Changing Engine Oil And Filter (F); Changing Engine Oil And Filter (F) - Cushman 646442 Owner's Manual

7
hauler 4x4 Diesel
-12

ChANGING ENGINE oIl AND fIlTER (f)

1. Warm up the engine oil by operat-
ing the engine for approx. 10 min-
utes or driving the vehicle.
2. park the vehicle on level ground,
stop the engine and apply the
parking brake firmly.
3. remove the inspection shield and
seat cushion.
(1) Drain plug
4. place a container under the drain
plug and remove the drain plug to
drain the oil to the container. be
careful as the engine oil may be
hot.
(1) Oil filter
5. remove the oil filter through the
inspection shield and discard it.
6. Apply a thin film of oil to the rub-
ber O-ring of a new oil filter. Then,
install it by tightening it firmly to its
UUVo709A
end by hand.
7. Install the drain plug firmly.
UUVo710A
(1) filler cap
8. Open the filler cap and slowly add
new oil.
9. the engine oil capacity for this ve-
hicle is as follow.
oil Capacity
10. Install the filler cap.
11. start the engine and run it at a
low speed without load. then,
check if any oil has leaked.
UUVo711A
0.85 u.s.gal. (3.2 l)