Fueling Instructions - Gasoline Vehicles - Husqvarna HUV4210-G Owner's Manual

Fueling Instructions – Gasoline Vehicles
NOTE: Using multi-grade oils (5W-20, 10W-30, and 10W-40) will increase oil consumption. Check oil level more
frequently when using them.
SAE 10W-30/ SAE 10W-40
SAE 5 W-30
213
Figure 30 Oil Viscosity Chart
FUELING INSTRUCTIONS – GASOLINE VEHICLES
See General Warnings on page 10.
DANGER
• Turn the key switch to the OFF position before fueling.
• Do not pour fuel into the fuel tank when the engine is hot or while it is running.
• To avoid electric arc caused by static electricity, the fuel storage/pumping device must be grounded. If
the pump is not grounded, the vehicle must be grounded to the pump before and during the fueling
operation.
• If the vehicle has an all-weather enclosure installed, be sure the fuel tank is properly vented as shown
(Figure 31).
• To avoid the possibility of fire, clean up any spilled fuel before operating the vehicle.
CAUTION
• To allow for expansion, do not fill higher than 2.54 cm (one inch) from the top of the fuel tank. Avoid
spilling fuel.
NOTE: Whenever possible, avoid using oxygenated fuels and fuels that are blended with alcohol. Vehicles to be
stored for extended periods should be prepared for storage as instructed. See Preparing the Gasoline
Vehicle for Extended Storage on page 29.
1. Turn the key switch to the OFF position.
2. Lift and remove seat bottom.
3. The fuel tank is located on passenger side of vehicle. Remove fuel cap and fill the fuel tank with fresh unleaded
gasoline only. See preceding CAUTION.
4. Replace fuel cap on tank. Ensure cap is tightened securely.
5. Replace seat bottom.
Page 46 2009 HUV4210 Owner's Manual
SAE 30