Pre-Operation And Daily Safety Checklist - Husqvarna HUV4210-G Owner's Manual

2009 huv4210 series
Hide thumbs Also See for HUV4210-G:
Table of Contents

Advertisement

Pre-Operation and Daily Safety Checklist

LOW OIL WARNING LIGHT
Gasoline Vehicles Only
The gasoline golf car is equipped with a low oil warning light (1), located on the dash panel to the right of the key
switch (Figure 15). If the warning light comes on, oil should be checked and added to the engine as necessary before
continuing to use the vehicle. The vehicle should never be driven with the low oil warning light remaining on. If the
warning light goes on and off, you may proceed, but oil should be added at the first opportunity. If the oil level is correct
and the warning light stays on, have a trained technician check the vehicle. See following CAUTION.
CAUTION
• Failure to add oil immediately when the low oil warning light stays on may result in permanent
engine damage.
HEADLIGHT CONTROL
The headlight control (2) is located on the dash to the left of the key switch (Figure 15). Pull out to turn the lights on,
push in to turn the lights off. The headlights operate on 12 volts DC from the battery. See following NOTE.
NOTE: Using the headlights for extended periods of time without the engine running, or with the engine idling, will
discharge the battery.
12-VOLT OUTLET ACCESSORY
Some vehicles are provided with a 12-volt outlet, protected with a 10 amp fuse, located in the fuse box under the seat.
To use, push in a cord designed for this type of outlet.
Be sure to disconnect electronic devices from the accessory outlet before the vehicle batteries are charged. See
following CAUTION.
CAUTION
• Do not leave electronic devices connected to the accessory outlet while the vehicle batteries are being
charged. The voltage output can fluctuate from 12 volts to 19 volts while the vehicle batteries are
charging, and this voltage fluctuation can damage some electronic devices.
To remove a power cord from the accessory outlet, rotate it counterclockwise, align the arrows and pull the cord out
of the outlet.
Extended use of this accessory can cause the batteries to become heavily discharged. If the vehicle batteries become
deeply discharged, charge the batteries as instructed in the owner's manual appropriate to the vehicle, or contact
your local Husqvarna dealer for instructions.
Inspect the accessory outlet periodically to ensure the electrical connection is clean and free of corrosion.
PRE-OPERATION AND DAILY SAFETY CHECKLIST
Each Husqvarna vehicle has been thoroughly inspected and adjusted at the factory; however, upon receiving your new
vehicle(s), you should become familiar with its controls, indicators, and operation. Carefully inspect each vehicle to
ensure that it is in proper working condition before accepting delivery.
Use the following checklist as a guide to inspect the vehicle. This checklist should be used daily to ensure that
the vehicle is in proper working condition and in conjunction with the Performance Inspection on page 21 and the
Periodic Service Schedules on page 31. Any problems should be corrected by a Husqvarna distributor/dealer or a
trained technician.
Page 20
2009 HUV4210 Owner's Manual

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Huv4210-eHuv4210-gxpHuv4210-exp

Table of Contents