For Vigor2820Vsn - Draytek Vigor2820 Series User Manual

1 . 2 . 5 F o r V i g
1 . 2 . 5 F o r V i g
LED
ACT (Activity)
USB
CSM
WLAN
DSL
WAN 2
Line
Phone
QoS
LED on Connector
Phone S0
ISDN/
Phone S0
Vigor2820 Series User's Guide
o r 2 8 2 0 V S n
o r 2 8 2 0 V S n
Status
Blinking
Off
On
Blinking
On
On
Blinking
On
Blinking
On
Blinking
On
Off
On
Off
Blinking
On
On
Left LED
(Orange)
Blinking
On
Right LED
Blinking
(Green)
On
Left LED
(Orange)
Blinking
Off
Right LED On
(Green)
Blinking
Explanation
The router is powered on and running normally.
The router is powered off.
A USB device is connected and active.
The data is transmitting.
The profile of CSM (Content Security Management) for
IM/P2P application is enabled from Firewall >> General
Setup. (Such profile is established under CSM menu).
Wireless access point is ready.
It will blink while wireless traffic goes through.
The router is ready to access Internet through DSL link.
Slowly: The DSL connection is ready.
Quickly: The connection is training.
The WAN1 or WAN2 connection is ready.
It will blink while transmitting data.
A PSTN phone call comes (in and out). However, when the
phone call is disconnected, the LED will be off about six
seconds later.
There is no PSTN phone call.
The phone connected to this port is off-hook.
The phone connected to this port is on-hook.
A phone call comes.
The QoS function is active.
ISDN NT (ISDN S0 intern) mode is active and an ISDN phone
adapter is connected.
ISDN NT (ISDN S0 intern) mode is active and an ISDN phone
adapter is not connected.
A phone has been connected. If not, green LED will be off.
An ISDN phone is off-hook or a phone call comes.
ISDN NT (ISDN S0 intern) mode is active configured from
VoIP>>Phone Settings and an ISDN phone adapter is
connected.
ISDN NT (ISDN S0 intern) mode configured from
VoIP>>Phone Settings is active and an ISDN phone adapter
is not connected.
It means ISDN TE mode is active which is configured from
VoIP>>Phone Settings.
A phone adapter with phone set has been connected (ISDN S0
intern mode) or ISDN line has been connected (ISDN S0
extern mode). It will be off if there is nothing connected.
In ISDN NT (ISDN S0 intern) mode, it means an ISDN phone
is off-hook or a phone call comes.
In ISDN TE mode, it means data, fax or voice (phone call) is
transmitting.
11