For Vigor2820Vn - Draytek Vigor2820 Series User Manual

1 . 2 . 3 F o r V i g
1 . 2 . 3 F o r V i g
LED
ACT (Activity)
USB
CSM
WLAN
DSL
WAN 2
Line
Phone 1/2
LED on Connector
LAN
1(Giga)
LAN
2/3/4
WAN 2
Vigor2820 Series User's Guide
o r 2 8 2 0 V n
o r 2 8 2 0 V n
Status
Blinking
Off
On
Blinking
On
On
Blinking
On
Blinking
Left LED On
(Green)
Off
Blinking
Right LED On
(Green)
Off
On
Off
On
Off
Blinking
Left LED On
(Green)
Off
Blinking
Right LED On
(Green)
Off
Left LED On
(Green)
Off
Blinking
Right LED On
(Green)
Off
Left LED On
(Green)
Off
Blinking
Right LED On
(Green)
Off
Explanation
The router is powered on and running normally.
The router is powered off.
A USB device is connected and active.
The data is transmitting.
The profile of CSM (Content Security Management) for
IM/P2P application is enabled from Firewall >> General
Setup. (Such profile is established under CSM menu).
Wireless access point is ready.
It will blink while wireless traffic goes through.
The router is ready to access Internet through DSL link.
Slowly: The DSL connection is ready.
Quickly: The connection is tranning.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 100Mbps.
The port is disconnected with 10Mbps.
A PSTN phone call comes (in and out). However, when the
phone call is disconnected, the LED will be off about six
seconds later.
There is no PSTN phone call.
The phone connected to this port is off-hook.
The phone connected to this port is on-hook.
A phone call comes.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 1000Mbps.
The port is disconnected with 10/100Mbps.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 100Mbps.
The port is disconnected with 10Mbps.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 100Mbps.
The port is disconnected with 10Mbps.
7