Lift Cylinder - Toro GroundsmasterR 4300-D Service Manual

Lift Cylinder

RIGHT
FRONT
11
12
13
12
11
1. Lift cylinder
2. Pivot shaft
3. Flange head screw
4. Lift arm (#1 shown)
5. Flat washer
NOTE: The procedure for lift cylinder removal and
installation is the same for all Groundsmaster 4300--D
lift cylinders. Figure 93 shows the center, front (deck #1)
lift cylinder.
Removal (Fig. 93)
1. Park the machine on a level surface, engage the
parking brake, lower the cutting decks and stop the en-
gine. Remove the key from the ignition switch.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Hydraulic System
10
7
6
8
9
3
4
67 to 83 ft- -lb
(91 to 112 N- -m)
Figure 93
6. Hydraulic hose
7. O- -ring
o
8. 90 hydraulic fitting
9. O- -ring
Page 4 - - 104
1 2
5
GROUNDSMASTER
4300- -D CUTTING
DECK LOCATIONS
FRONT
Figure 94
10. Hydraulic hose
11. Retaining ring
12. Thrust washer
13. Cylinder slide pin
#4 #1 #5
#2 #3
Groundsmaster 4300--D