Toro GroundsmasterR 4300-D Service Manual page 87

IMPORTANT: When capping lift cylinder fitting and
hydraulic hose end, use a steel cap and plug to en-
sure that fluid leakage will not occur. Plastic plugs
will not hold hydraulic pressure that will be devel-
oped during this test procedure.
4. Place a steel cap on the open lift cylinder fitting to
seal the lift cylinder. Also, install a steel plug in the open
end of the disconnected hose to prevent leakage or con-
tamination.
5. Slowly lower the jack and remove it from under the
lift arm. The cutting deck should settle slightly and then
be supported by the capped lift cylinder.
6. Mark the position of the lift cylinder rod at the lift cylin-
der head with a piece of tape (Fig. 57).
7. Leave the machine parked for two (2) hours and
monitor the lift cylinder. The weight of the cutting deck
may cause the lift cylinder to gradually extend. Use the
tape location to determine lift cylinder rod movement
(Fig. 58).
A. If lift cylinder rod movement is less than 1.250"
(31.7 mm) after two (2) hours, make sure that the cut-
ting deck has not settled to the ground. If the cutting
deck is still suspended after two (2) hours and lift cyl-
inder rod movement is less than 1.250" (31.7 mm),
consider that the lift cylinder is in good condition. A
cylinder in good, usable condition will show minimal
movement.
B. Rod movement in excess of 1.250" (31.7 mm) af-
ter two (2) hours indicates that the lift cylinder may
have internal seal damage or excessive wear. Re-
move and inspect the lift cylinder (see Lift Cylinder
and Lift Cylinder Service in the Service and Repairs
section of this chapter).
8. Once lift cylinder condition has been determined,
use a jack to raise the lift arm slightly which will remove
the load from the lift cylinder. Leave the jack to support
the lift arm and to prevent it from lowering. Remove the
cap from the cylinder fitting and the plug from the hy-
draulic hose. Connect the hydraulic hose to the lift cylin-
der fitting.
9. Carefully remove jack from under the lift arm. Start
engine and operate lift cylinders through several up and
down cycles. Stop the engine and check for any leak-
age.
10.If needed, repeat steps 2 through 10 for other lift cyl-
inders.
11. After testing is complete, check oil level in hydraulic
reservoir and adjust if necessary.
Groundsmaster 4300--D
1. Lift cylinder (#5 shown)
2. Cylinder rod end fitting
1. Lift cylinder rod
2. Lift cylinder head
1. Tape (after 2 hours)
Page 4 - - 55
3
2
1
Figure 56
3. Hydraulic hose
1
3
2
Figure 57
3. Tape (initial position)
2
1
Figure 58
2. Cylinder rod movement
Hydraulic System