Specifications - Toro GroundsmasterR 4300-D Service Manual

Specifications

MOUNTING: All cutting decks are supported by inde-
pendent lift arms and are interchangeable to any cutting
deck positions. The Groundsmaster 4300--D uses five
(5) cutting decks.
CONSTRUCTION: Deck chamber and frame are
welded steel construction reinforced with channels and
plates.
HEIGHT- -OF- -CUT RANGE: 3/4 to 4 inch (19 to 101
mm) in 1/4 inch (6.4 mm) increments. Height--of--cut ad-
justment is made by repositioning deck on deck frame.
DECK DRIVE: Closed loop, integrated relief, hydraulic
system operates cutting deck hydraulic motors. Blade
spindles are 1--1/4 inch (31.7 mm) shafts supported by
greaseable, tapered roller bearings in a ductile iron
housing.
CUTTING BLADE: Each cutting deck equipped with a
22 inch (559 mm) length, 0.250 inch (6.4 mm) thick, heat
treated, steel blade. Anti--scalp cup installed on cutting
blade. The standard blade is optimized for most cutting
applications. Optional high lift, angled sail and Atomic
blades are available for those situations where the stan-
dard blade is not ideal.
Cutting Decks
DISCHARGE: Clippings are discharged from the rear of
the mowing decks. Pre--drilled mounting holes in the
cutting deck allow attachment of optional mulching
baffle.
CUTTING DECK LIFT: Cutting decks on the Ground-
smaster 4300--D are controlled with the operator joy-
stick.
SUSPENSION SYSTEM: A fully floating suspension
with hydraulic counterbalance. Main center pivot allows
side--to--side deck oscillation. Individual decks sup-
ported with two (2) front rollers and one, full width, rear
roller.
WEIGHT: Individual cutting deck weighs approximately
140 lb (63.5 kg).
Page 7 - - 2 Groundsmaster 4300--D