Ask Proxima E1655 series User Manual page 18

Connecting to the AC power cord
This projector uses nominal input voltages of 100–240 V AC
and it automatically selects the
designed to work with a single-phase power system having a
grounded neutral conductor. To re
shock, do not plug into any other type of power system. If
you are not sure of the type of power being supplied, consult
your authorized dealer or
projector with all peripheral equipment before turning it on.
The AC outlet should be near this equipment and must be easily accessible.
Note:

Unplug the AC power cord when the projector is not in use. When the
projector is connected to an outlet with AC power cord, it is in stand-by
mode and consumes a little electric power.
Note on the power cord
AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If the supplied AC power cord does not match
Projector side
To power cord connector
on your projector.
Note:

Using incorrect power cord may influence the product performance, or even cause hazards like an electric shock
or fire. To ensure the product performance and security, please apply the cable of the same model with the original
one.
Common connecting cables include the AC power cord, vari ous VGA cables, audio cable, video cable, and serial
control cable.
correct input voltage. It is
duce the risk of electrical
service station. Connect the
17
Installation
Connect the AC power cord
(supplied) to the projector.
AC outlet side
Ground
To the AC outlet.
(100-240 V AC)