Table of Contents
Advertisement
Seek Tuning
Each time you push this button up or down, the tuner will
automatically seek the next higher or lower frequency station.
Preset Station Selection
1 .Select AM or FM band by depressing the Band Selector. Find the
station you want by Manual Tuning or Seek Tuning.
Press and hold one of the Preset Buttons.
2. In a few seconds, a beep will sound and the light in the button will
3. come on. The station is now preset in the memory. You may
preset 1 AM and 1 FM station per button.
(total, 6 of each on the 2.0 S and 2.0 Si models and 8 of each on
the Si model).
4. You can tune to a preset station by pushing its corresponding
preset button.
NOTE: On the Si model
The Auto Preset button must be off before the Preset Station
Selection can be used.
Auto Select Button (Si only)
If you are visiting a new broadcast area, you can quickly enter into
memory the stronger stations in that area by simply pushing the
Auto Select Button. The radio will then automatically scan the AM
and FM bands and temporarily memorize up to eight stations in each.
With the Auto Select Button on, these stations can then be tuned
by pushing the preset buttons. Manually-preset stations remain
memorized for use when you return to your normal broadcast area,
but are only selectable with the Auto Select Button off.
Stereo indicator
This lights up when an FM broadcast in stereo is being received. It
will flash when the signal strength diminishes. If it flashes, good
stereo reception cannot be expected. Stereo reception is available
only for FM stereo broadcasts, not for AM stereo broadcasts.
(cont'd)
Hide quick links:
Advertisement
Table of Contents
