DAELIM S4 50cc Service Manual page 82

BELT TYPE CONTINUOUSLY VARIABLE TRANSMISSION / KICK STARTER
FLANGE NUT FLANGE NUT FLANGE NUT FLANGE NUT FLANGE NUT
FLANGE NUT FLANGE NUT FLANGE NUT FLANGE NUT
FLANGE NUT FLANGE NUT FLANGE NUT FLANGE NUT FLANGE NUT FLANGE NUT
FLANGE NUT FLANGE NUT FLANGE NUT FLANGE NUT FLANGE NUT FLANGE NUT
FLANGE NUT
7-14
● Assemble drive face to the serration side of LH.
Crank shaft, then assemble hext nut 12mm.
● By using drive face holde, fasten drive face nut.
TORQUE : 5.5kgf·m
TOOL : DRIVE FACE
NOTE
•Assemble drive pulley nut as specified torque.
•Assemble by completely fitting drive face and
crankshaft sereration.
•Fix fly wheel to universal holder if drive pulley
holder can not be used.
● Assemble 2 dowel pins and gasket
● Assemble LH. Side cover .