Brake Fluid Replacement - DAELIM S4 50cc Service Manual

FRONT WHEEL / FRONT BRAKE / FRONT FORK / STEERING STEM
"UP" MARK "UP" MARK "UP" MARK "UP" MARK "UP" MARK "UP" MARK "UP" MARK
"UP" MARK "UP" MARK "UP" MARK "UP" MARK "UP" MARK "UP" MARK
"UP" MARK "UP" MARK "UP" MARK "UP" MARK
"UP" MARK "UP" MARK "UP" MARK "UP" MARK "UP" MARK
BOOT BOOT BOOT
BOOT BOOT BOOT BOOT
BOOT BOOT BOOT BOOT BOOT BOOT
BOOT BOOT BOOT BOOT BOOT BOOT
BOOT BOOT BOOT
DIAPHRAGM PLATE DIAPHRAGM PLATE DIAPHRAGM PLATE
DIAPHRAGM PLATE DIAPHRAGM PLATE DIAPHRAGM PLATE DIAPHRAGM PLATE
DIAPHRAGM PLATE DIAPHRAGM PLATE DIAPHRAGM PLATE DIAPHRAGM PLATE DIAPHRAGM PLATE DIAPHRAGM PLATE
DIAPHRAGM PLATE DIAPHRAGM PLATE DIAPHRAGM PLATE DIAPHRAGM PLATE DIAPHRAGM PLATE DIAPHRAGM PLATE
DIAPHRAGM PLATE DIAPHRAGM PLATE DIAPHRAGM PLATE
NOTE
•When installing the cups, do not allow to close the
cup ends.
•nstall the spring with it's smaller direction of coil
ends toward the piston.
● Install the cir clip to the mater cylinder groove firmly.
TOOL: SNAP RING PLIER
● Assemble boot to master cylinder.
INSTALLATION
● Install the front master cylinder to the handle.
NOTE
•Install the holder with its "UP"mark facing
upwards, and align the holder joint with the punch
mark on the handle bar.
•Tighten the holder upper bolt first.
● Install the brake hose to the master cylinder with 2
new sealing washers and the hose bolt.
TORQUE : 3.0 kgf·m
● Loosen the 2 flat screws, remove the oil cup cap,
diaphragm.
● Fill the brake fluid and bleed air.
● Install the diaphragm, diaphragm plate and oil cup
cap, tighten the 2 flat screws.

BRAKE FLUID REPLACEMENT

NOTE
•A contaminate disk or pad reduces braking power.
Do not allow the disk or pad to be contaminated by
oil.
•Replace contaminated pads, and remove pollutants
from the disk completely.
•Check the brake fluid level often and replenish
new fluid as requires.
•Do not spill fluid on painted, plastic or rubber
parts.