Daikin FTXZ25NV1B Service Manual page 111

SiMT041311E
< To change or cancel the setting >
1.
Follow steps 1 and 2 on page 21 and then select the timer setting you want to
change.
2.
Press to select the item and press
Setting change
TIMER cancel
• Settings can be cancelled with
• If you cancel the QUICK HEATING TIMER operation halfway through, the operation goes back to the normal HEATING operation
Pressing
< To stop the operation >
Press
Example
QUICK HEATING time is set to 7:00.
is pressed.
6:30
QUICK HEATING time
Preparatory heating operation starts.
Notes on warmth zone
• By blowing warmer air than the normal setting at a
lower airflow rate, a warmth zone is created around
the indoor unit.
• This function is effective within about 1.5m or less
from the wall where the indoor unit is installed.
Notes on QUICK HEATING TIMER operation
• To blow warm air quickly, preparatory heating operation is performed for about 30 minutes before and after the set QUICK HEATING
time. In this step, electric power is consumed.
• During the preparatory heating operation the flaps open and the fan starts rotating. Also warm air may be blown.
• If you go out and do not use the air conditioner for a long time, cancel the QUICK HEATING TIMER.
• Warm air may be blown at a later stage just after the QUICK HEATING TIMER lamp becomes red or when the protection control works.
• When the indoor temperature is 20˚C or higher, or when the outdoor temperature is 16˚C or higher, the preparatory heating operation
does not start.
• "URURU" HUMIDIFY operation is not performed while the QUICK HEATING TIMER operation is performed.
Installation / Operation Manual
.
also goes back to the normal HEATING operation.
.
If is not pressed, the
air conditioner stops
operating.
is pressed.
7:00 7:30
.
QUICK HEATING TIMER is set.
(QUICK HEATING TIMER lamp (dark red)
lights up.)
Preparatory heating operation is running.
(QUICK HEATING TIMER lamp (bright red)
lights up.)
QUICK HEATING TIMER operation is running.
(QUICK HEATING TIMER lamp (bright red)
and OPERATION lamp (green) light up.)
Normal HEATING operation is running.
(OPERATION lamp (green) lights up.)
Vertical
airflow direction
Horizontal
airflow direction
The vertical airflow direction is set at the
5th level. The horizontal airflow direction
preserves the previous settings.
Warmth zone
Operation Manual
22
96