Self-Diagnosis By Remote Controller; How To Use Remote Controller In Service Mode - Toshiba RAS-13UKV-E Service Manual

10-4. Self-Diagnosis by Remote Controller (Check Code)
(1) If the lamps are indicated as shown B to H in Table 10-3-1, excute the self-diagnosis by the remote control-
ler.
(2) When the remote controller is set to the service mode, the indoor controller diagnoses the operation condi-
tion and indicate the information of the self-diagnosis on the display of the remote controller with the check
codes. If a fault is detected, all lamps on the indoor unit will flash at 5Hz and it will beep for 10 seconds
(Pi, Pi, Pi ... ). The timer lamp usually flashes (5Hz) during self-diagnosis.

10-4-1. How to Use Remote Controller in Service Mode

AUTOA
AM
PM
P ON
OFF
˚ C
AM
PM
HiPOWER
CHK AUT UTO
START/STOP
FAN MODE
SWING ECO
TIMER
FIX
ON OFF SET
FILTER
RESET CLOCK CHECK
WH-C1PE
Alphanumeric characters are
used for the check codes.
is 5. is 6.
is A. is B.
is C. is D.
SET CLR
RESET CLOCK CHECK
:
:
PRESET
AUTO
Hi-POWER
MEMO
CLR
1
Push [CHECK] button with a tip of pencil to set the
remote controller to the service mode.
• " " is indicated on the display of the remote
controller.
• The timer lamp of the indoor unit flashes continuously.
(5 times per 1 sec.)
2
Push [TIMER ] button
If there is no fault with a code, the indoor unit will beep
once (Pi) and the display of the remote controller will
change as follows :
• Check the unit with all 35 check codes (
as shown in Table-10-4-1.
• Push [TIMER
backward.
If there is a fault, the indoor unit will beep for 10
seconds (Pi, Pi, Pi...).
Note the check code on the display of the remote
controller.
• 2-digits alphanumeric will be indicated on the display.
• All lamps on the indoor unit will flash.
(5 times per 1 sec.)
3
Push [START/STOP] button to release the service mode.
• The display of the remote controller returns to as it
was before service mode was engaged.
Fig. 10-4-1
– 47 –
• • •
] button to change the check code
to )