Remote Controller And Its Fuctions; Parts Name Of Remote Controller - Toshiba RAS-13UKV-E Service Manual

8-6. Remote Controller and its Fuctions

8-6-1. Parts Name of Remote Controller

1
Infrared signal emitter
Transmits a signal to the indoor unit.
2
START/STOP button
Push the button to start operation.
(A receiving beep is heard.)
Push the button again to stop operation.
(A receiving beep is heard.)
If no receiving sound is heard from the indoor unit,
push the button twice.
3
Mode select button (MODE)
Push this button to select a mode.
Each time you push the button, a mode is selected in
a sequence that goes from A : Auto changeover
control, : Cool,
and back to A. (A receiving beep is heard.)
4
Temperature button
..... The set temperature is increased up to 30°C.
..... The set temperature is dropped down to 17°C.
(A receiving beep is heard.)
5
Fan speed button (FAN)
Push this button to select fan speed. When you
select AUTO, the fan speed is automatically adjusted
according to the room temperature.
You can also manually select the desired fan speed
from among five settings.
(LOW , LOW + , MED
HIGH ) (A receiving beep is heard.)
6
Auto louver button (SWING)
Push this button to swing the louver.
(A receiving beep is heard.)
Push the FIX button to stop the louver swinging.
(A receiving beep is heard.)
7
Set louver button (FIX)
Push this button to adjust the air flow direction.
(A receiving beep is heard.)
8
Off timer button (OFF)
Push this button to set the OFF timer.
9
On timer button (ON)
Push this button to set the ON timer.
10
Reserve button (SET)
Push this button to reserve
time settings.
(A receiving beep is heard.)
: Dry, : Heat, : Fan only,
, MED + ,
4
2
5
6
7
9
8
16
11
Cancel button (CLR)
Push this button to cancel ON timer and OFF timer.
(A receiving beep is heard.)
12
High power button (Hi-POWER)
Push this button to start the high power operation.
13
Memory button (MEMO)
Keep pushing the MEMO button for 2 seconds from
the beginning, or keep pushing the button for 2
seconds after pushing it once for a short time. Then
the set data is stored in the memory and
displayed.
14
Automatic operation button (AUTO)
Push this button to operate the air conditioner
automatically.
15
ECO timer button (ECO)
Push this button to start the ECO timer (OFF timer)
operation.
You can select the OFF timer from among four
settings (1, 3, 5 or 9 hours).
16
FILTER button
Push this button to turn off the filter cleaning lamp on
the indoor unit.
Push this button after cleaning the air filter.
17
PRESET button
Push this button to operate the air conditioner
according to settings memorized by the MEMO
button.
18
TIMER button
Use this button to change the clock, ON timer, and
OFF timer times.
To forward the time, push the "TIMER
To set back the time, push the "TIMER
1
AUTOA
AM
PM
ON
P
OFF
˚ C
AM
PM
HiPOWER
CHK AUT UTO
PRESET
START/STOP
FAN MODE
SWING ECO
TIMER TIMER
FIX
ON OFF SET
FILTER
RESET CLOCK CHECK
– 32 –
" button.
:
:
3
AUTO
15
Hi-POWER
13
MEMO
CLR
10
is
P
" button.
17
14
12
11
18