Toshiba RAS-13UKV-E Service Manual page 65

No. Part name
†
Cross flow 1) Remove the front panel, electrical part, horizon-
fan
2) Remove 2 screws of the band motor (L) and
3) Loose the set screw of the cross flow fan then
Notice :
For position of the fan motor connector and drawing
out of the lead cables, refer to the procedure
Fix the cross flow fan with the set screw at the
position where the gap between the back body and
the right surface of the cross flow fan is 4.5 mm.
‡
Base bearing 1) Remove the front panel, electrical part, horizon-
2) Remove 2 screws fixing the base bearing.
3) Remove the bearing from the base bearing.
Procedures
tal louver and the heat exchanger with the
„
procedure .
other 2 screws of the band motor (R) and then
remove the cross flow fan.
disconnect the fan and the fan motor.
tal louver, heat exchanger and the cross flow fan
…
with the procedure .
If the housing protrudes from the base bearing,
put the housing in position and attach the
bearing to the base bearing.
…
.
– 65 –
Remarks
4
2-Screws
(R)
2 2-Screws (L)
4.5 mm
6 Set screw
4
2-Screws