Toshiba RAS-13UKV-E Service Manual page 67

11-3. Outdoor Unit
No. Part name

1. Detachment
Common
procedure
1) Stop operation of the air conditioner, and turn
2) Remove the valve cover. (ST1TØ4 x 10 1 pc.)
3) Remove wiring cover (ST1TØ4 x 10 2 pcs.),
4) Remove the upper cabinet.
2. Attachment
1) Attach the upper cabinet.
2) Perform cabling of connecting cable, and attach
3) Attach the valve cover. (ST1TØ4 x 10 1 pc.)
‚
1. Detachment
Front cabinet
1) Perform work of item 1 of
2) Remove screws (ST1TØ4 x 10 2 pcs.) of the
2. Attachment
1) Insert claw at the left side of the front into the
2) Hook the lower part at the right side of the front
3) Attach the removed screws to the original
Table-11-3-1
Procedure
off the main switch of the breaker for air condi-
tioner.
• After removing screw, remove the valve cover
pulling it downward.
and then remove connecting cable.
(ST1TØ4 x 10 2 pcs.)
• After removing screws, remove the upper
cabinet pulling it upward.
(ST1TØ4 x 10 2 pcs.)
• Hook the rear side of the upper cabinet to
claw of the rear cabinet, and then put it on the
front cabinet.
the wiring cover.
• Insert the upper part into the upper cabinet,
insert claw which has been hooked to the
lower part into the square hole, and then fix it
with screw. (ST1TØ4 x 10 1 pc.)
• Insert the upper part to the upper cabinet, set
hook claw of the valve cover to square holes
(at three positions) of the main unit, and
attach it pushing upward.
front cabinet and inverter cover and screws
(ST1TØ4 x 10 3 pcs.) of the front cabinet and
lower part.
• The left side of the front is made to insert to
the rear cabinet, so remove it pulling upward.
rear cabinet.
to concave part of the bottom plate. Insert claw
of the rear cabinet into square hole of the front
cabinet.
positions.

.
– 67 –
Remarks
Upper cabinet
Claw
Square hole
Concave section
Wiring
cover
Valve
cover