Installation Diagram Of Indoor And Outdoor Units - Toshiba RAS-13UKV-E Service Manual

CAUTION
• Exposure of unit to water or other moisture before installation will result in an electrical short.
Do not store in a wet basement or expose to rain or water.
• After unpacking the unit, examine it carefully for possible damage.
• Do not install in a place that can increase the vibration of the unit. Do not install in a place that can
amplify the noise level of the unit or where noise and discharged air might disturb user's neighbors.
• To avoid personal injury, be careful when handling parts with sharp edges.
• Please read the installation manual carefully before installing the unit. It contains further important
instructions for proper installation.
For general public use

9-1-1. Installation Diagram of Indoor and Outdoor Units

2 Wireless
remote controller
5 Zeolite
filter
8 Flat head
wood screw
4 Remote controller
holder
Before installing the
wireless remote controller
• With the remote controller
cover open, load the batteries
supplied correctly, observing
their polarity.
2 Wireless
remote controller
Cover
3
Batteries
Power supply cord of parts of appliance for outdoor use shall be more
than polychloroprene sheathed flexible cord (design H07 RN-F), or
cord designation 245 IEC 66. (1.5mm² or more)
Hook
Vinyl tape Apply
after carrying out
a drainage.
6 Purifying
filter
As shown in the figure,
hang power cord and
connecting cable downward,
and take out it along piping
connection port.
Fig. 9-1-1
Hook
1 Installation
plate
Insert the cushion between the indoor
unit and wall, and lift indoor unit for
better operation.
Do not allow the drain hose to get slack.
Shield
pipe
Make sure to run the drain hose sloped
downward.
The auxiliary piping can be connected
the left, rear left, rear, right or bottom.
Saddle
Right
Rear right
Insulation of refrigerant pipes insulates
the pipes separately, not together.
Extension drain hose
(Option : RB-821SW)
– 36 –
For the rear left and left piping
Wall
Cut the piping hole
sloped slightly
Bottom right
Rear left
Bottom left
6 mm thick heat resistin gpolyethylene foam
Left