Armrest Width Adjustment - Pride Mobility LEGEND Owner's Manual

V I I I .

ARMREST WIDTH ADJUSTMENT

The Legend armrest width can be adjusted inward or outward.
1. Loosen the armrest adjustment knobs at the back of the seat frame. See figure 16.
2. Slide the armrests in or out to the desired width.
3. Tighten the armrest adjustment knobs.
The armrests can also be lifted upward to allow getting on and off of your Legend easier.
ARMREST HEIGHT ADJUSTMENT
Refer to figure 16 when adjusting the armrest height.
You will need the following tools to adjust the height of the armrests:
• 5/32in. Hex Key •1/8in. Hex Key • 7/16in. Wrench
1. Loosen the setscrew on the side of the height adjustment tube with the 1/8” hex key. See figure 16.
2. Loosen and remove the acorn nut and screw holding the height adjustment tube in place.
3. Raise or lower the height adjustment tube to the desired height.
4. Align the holes in the adjustment tube with the holes in the armrest upright.
5. Insert the screw through the holes in both the height adjustment tube and the armrest upright.
6. Install and tighten the acorn nut.
7. Tighten the setscrew on the side of the height adjustment tube.
8. Repeat for the other armrest.
ACORN NUT
ARMREST UPRIGHT
ARMREST ADJUSTMENT
KNOB
30
C O M F O R T A D J U S T M E N T S
FIGURE 16. ARMREST ADJUSTMENTS
HEIGHT ADJUSTMENT TUBE
SETSCREW
Legend