Pride Mobility LEGEND Owner's Manual page 36

X I . B A S I C
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC FLASH CODES
The diagnostic flash codes for your Legend are designed to help you perform basic troubleshooting quickly and
easily. A diagnostic flash code will flash from the status LED in the event one of the conditions listed below
develops.
NOTE: Your scooter will not run unless the flash code condition is resolved and the scooter has been
turned off then turned back on.
FLASH CODE
n n n n n
n n
n n n
n n n n n
n n n n n n
What if all the systems on my Legend seem to be “dead”?
n Make certain that the key is in the on position.
n Check that the batteries are fully charged. See VI. “Batteries and Charging.”
n Push in the reset button of the main circuit breaker. See V. “Your Legend.”
n Make certain that both battery harnesses are firmly connected to the rear electronics module and to the battery
terminals. See IX. “Disassembly and Assembly.”
n Make sure that the silver front-to-rear harness is firmly connected to the rear electronics module . See IX.
“Disassembly and Assembly.”
n Be sure the auto shut off feature hasn’t been activated. See VI. “Batteries and Charging.”
What if the motor runs but my Legend does not move?
n Your Legend was probably left in freewheel mode.
n With the key turned on Check the status LED. If the LED flashes three times, a short pause, then flashes two
times, this is the manual freewheel lever code and means your Legend is in freewheel mode. See figure 7.
n When the manual freewheel lever is pulled up, the brakes are disengaged and all power to the transaxle is cut.
n Push down the manual freewheel lever to restore normal operation to your Legend. See V. “Your Legend.”
36
T R O U B L E S H O O T I N G
CONDITION
Batteries are too low to operate the
Scooter or the charger is operating.
Controller is hot; the Scooter seems to
be losing power.
n
Wigwag fault; your throttle control
levers are not responding.
The manual freewheel lever is in the
(up) freewheel position.
Scooter is operating with the charger
attached.
SOLUTION
Charge batteries or unplug the charger power
cord from the electrical outlet.
Shut down your Scooter for a minimum of
several minutes to allow the controller to
cool.
Call your authorized Pride provider for
assistance.
Turn the Scooter key to the off position, then
push the manual freewheel lever to the
(down) drive position, restart your Scooter.
Unplug the charger cord from the charger
power cord receptacle.
Legend