Armrest Angle Adjustment; Armrest Width Adjustment - Pride Mobility Wrangler Owner's Manual

V I I I . C O M F O R T A D J U S T M E N T S

ARMREST ANGLE ADJUSTMENT

The armrests of your Wrangler can be adjusted upward or downward. See figure 15.
n By turning the adjustment dial, the armrest will either raise or lower.
The armrests also pivot upward to make getting on and off of your Wrangler
ADJUSTMENT
easier.
DIAL
NOTE: If your Wrangler is not equipped with a reclining highback seat, as
shown in figure 13, you will be able to adjust the height and width of the
armrest by following the directions below.
FIGURE 15. ARMREST ANGLE
ARMREST HEIGHT ADJUSTMENT
ADJUSTMENT
You will need the following tools to adjust the height of the armrests:
• 5/32” Hex Key •1/8” Hex Key • 7/16” Wrench
1. Loosen the setscrew on the side of the height adjustment tube with the 1/8” hex key.
2. Loosen and remove the acorn nut and screw holding the height adjustment tube in place.
3. Raise or lower the height adjustment tube to the desired height.
4. Align the holes in the adjustment tube with the holes in the armrest upright.
5. Insert the screw through the holes in both the height adjustment tube and the armrest upright.
6. Install and tighten the acorn nut.
7. Tighten the setscrew on the side of the height adjustment tube.
8. Repeat for the other armrest.

ARMREST WIDTH ADJUSTMENT

The armrest width of your Wrangler can be adjusted inward or outward.
1. Loosen the armrest adjustment knobs at the back of the seat frame. See figures 16 and 17.
2. Slide the armrests in or out to the desired width.
3. Tighten the armrest adjustment knobs. The armrests can also be lifted upward to allow getting on and off of
your Wrangler easier.
HEIGHT ADJUSTMENT TUBE
ARMREST ADJUSTMENT KNOBS
ACORN NUT
SETSCREW
ARMREST
ADJUSTMENT
KNOB
FIGURE16. ARMREST HEIGHT ADJUSTMENT
FIGURE 17. ARMREST ADJUSTMENTS
26 Wrangler