Dual Access (Monochrome Only); Real Time Transmission - Brother MFC-3360C User Manual

Chapter 5
To change the default fax resolution
a
Make sure you are in Fax mode
b
Press Menu, 2, 2, 2.
c
Press a or b to choose the resolution
you want.
Press OK.
Note
You can choose four different resolution
settings for monochrome faxes and two
for colour.
Monochrome
Suitable for most typed
Standard
documents.
Good for small print and
Fine
transmits a little slower than
Standard resolution.
Good for small print or artwork
S.Fine
and transmits slower than Fine
resolution.
Use when the document has
Photo
varying shades of grey or is a
photograph. This has the
slowest transmission.
Colour
Suitable for most typed
Standard
documents.
Use when the document is a
Fine
photograph. The transmission
time is slower than Standard
resolution.
If you choose S.Fine or Photo and then
use the Colour key to send a fax, the
machine will send the fax using the Fine
setting.
24
Dual access
5
(Monochrome only)
.
You can dial a number and start scanning the
fax into memory—even when the machine is
sending from memory, receiving faxes or
printing PC data. The LCD shows the new job
number and available memory.
The number of pages you can scan into the
memory will vary depending on the data that
is printed on them.
Note
If the Out of Memory message appears
while scanning documents, press
Stop/Exit to cancel or Mono Start to send
the scanned pages.

Real time transmission

When you are sending a fax, the machine will
scan the documents into the memory before
sending. Then, as soon as the phone line is
free, the machine will start dialling and
sending.
If the memory is full or you are sending a
colour fax, the machine will send the
document in real time (even if
Real Time TX is set to Off).
Sometimes, you may want to send an
important document immediately, without
waiting for memory transmission. You can set
Real Time TX to On for all documents or
Next Fax Only for the next fax only.
5
5