Brother MFC-3360C User Manual page 96

c
Open the new ink cartridge bag for the
colour shown on the LCD, and then take
out the ink cartridge.
d
Remove the protective yellow cap (1).
1
Improper Setup
DO NOT touch the area shown in the
illustration below.
Note
If the protective yellow cap comes off
when you open the bag, the cartridge will
not be damaged.
86
e
Each colour has its own correct position.
Insert the ink cartridge in the direction of
the arrow on the label.
f
Lift the lock release lever and gently
push it until it clicks, and then close the
ink cartridge cover.
g
If you replaced an ink cartridge, the LCD
may ask you to verify that it was a brand
new one. (For example,
Did You Change Blck?) For each
new cartridge you installed, press 1
(Yes) to automatically reset the ink dot
counter for that colour. If the ink
cartridge you installed is not a brand
new one, be sure to press 2 (No).
If you wait until the LCD shows
Near Empty XX or Ink Empty XX,
the machine will automatically reset the
ink dot counter.
Note
If the LCD shows No Cartridge after
you install the ink cartridges, check that
the ink cartridges are installed properly.
M
brother
XXXX