Section 8: Removing & Installing The Door - Montigo R520 Installation & Maintenance Manual

Section 8: Removing & Installing the Door
Removing the door trim:
Follow the steps below to remove, or install the R520*
fireplace door trim.
Step 1:
Grasp the trim on either side of
the door with the tips of your
fingers. (Both sides Typ.) Pull
firmly to release the trim from
the internal door magnets.
Step 3:
Remove the trim from the bot-
tom of the door as shown.
XG0771 - 150204.3
Installation
Step 2:
Then, pull the trim from the top
of the door, as shown.
Step 4:
Remove the other side, as
shown in Steps 1 - 3.
R520 Power Vent Indoor Gas Fireplace
Removing the door:
Follow the steps to remove, or install the R520* fireplace door.
Step 1:
Remove glass suction cups from box and place on Glass door.
(The tool may not be exactly as shown).
Step 2:
Place the suction cups on the glass door, spaced evenly. (Ensure
they are firmly attached, and secured.)
Step 3: Lifting the glass panel.
Hold the Tools firmly and lift the glass panel up and out of the
lower track (Into the upper track). Tilt the lower edge of the door
panel outwards.
Step 4:
Ensure the top edge of the glass is fully removed from the upper
outer track, and Tilt / Lift away Cautiously from the fireplace.
Store in a safe location until time to replace.
Reinstalling the door:
Follow the four previous steps to re-install the R-Series fireplace
door.
Page 27