Adjustment
13
Stop positions
.05.13
5
2
2
1
2
or
13 - 35
Requirement
The machine must
1. be 4 mm before the BDC of the needle bar when sewing is interrupted and
2. position itself at the TDC of the needle bar after thread trimming.
Turn the machine off.
Select INPUT mode.
Select the input menu function (number key 5).
Select the SERVICE function.
Select the SEWING MOTOR function.
Select the ADJUST POSITIONS function.
Select the function BOTTOM POSITION or TOP POSITION.
Input the values which correspond to the requirements.