Programmed Sewing - Pfaff 421E1 Instruction Manual

10

Programmed sewing

.03
Pre-programmed seams can be selected with the program numbers 3 - 99.
Turn the machine on.
1 2 3 4 5 6 7
Fig. 10 - 04
Select the function select program.
3 9 9
to Enter the desired program number from 3 to 99.
Enter
Confirm this entry with the Enter key.
1 2 3 4 5 6 7
Fig. 10 - 05
Program interruption
This function interrupts the sewing of the seam program
(see chapter 10.05 Program interruption).
Needle up
By activating this function, the machine runs until the needle is at its top position when
stopping (without thread trimming).
Program selection
This function opens a direct menu for selecting the desired seam program.
Needle position
When this function is active, the machine positions the needle at its top position when
stopping. When this function is deactivated, the needle stops at its lowest position.
Roller presser up after stop
When this function is active, the roller presser is raised when the machine is stopped.
Roller presser down after trimming
When this function is active, the roller presser is lowered after the trimming process.
8 9 0
8 9 0
In the text line you will see a stylized seam behind the number of the current
seam section. Up-dating of the text line on a change of section is enabled or
disabled in the input menu under SERVICE/SEWING MOTOR/SEAM WITH
MOTOR RUNNING (see chapter 11.09 Summary of the service functions).
Esc
Clear
Enter
Esc
Clear
Enter
Sewing
10 - 4