Rear Fans; Installing Rear Fan Modules; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Fans
8.3

Rear fans

Two optional hot-pluggable rear fan modules can be added to the system for fan
redundancy.
V
CAUTION!
When equipping rear fans, ensure to always install both rear fan modules
in order to satisfy cooling requirements. Operation with only one rear fan
module is not possible.
8.3.1

Installing rear fan modules

Customer Replaceable Units (CRU)
Average task duration: 5 minutes
8.3.1.1

Required tools

Preliminary and concluding steps: tool-less
●
Replacing the fan module: tool-less
●
8.3.1.2

Preliminary steps

Before installing a rear fan module, perform the following steps:
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 79 (rack server) or
server).
392
"Extending the server out of the rack" on page
"Removing the side cover" on page 88
Upgrade and Maintenance Manual
77.
"Removing the top cover"
TX300 S7 / RX350 S7
76.
(tower