Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
7.3.9.7

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page 102.
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page
Ê Install HDD / SSD modules or HDD dummy modules into the additional HDD
slots as described in sections
page 216 and
page 222.
I
For detailed information on HDD mounting order, refer to section
inch HDD / SSD configurations" on page
Ê Close the side / top cover as described in section
on page 115 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
294
390.
112.
"Installing a 2.5-inch HDD / SSD module" on
"Installing a 2.5-inch HDD / SSD dummy module" on
"Mounting the side cover" on page 122
133.
Upgrade and Maintenance Manual
"Installing the system
"Installing the system air duct"
199.
"Mounting the top cover"
132.
130.
"Connecting the server to
TX300 S7 / RX350 S7
"2.5-
(tower