Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

7.4.5.2

Preliminary steps

Before installing the HDD extension box, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Shut down the server as described in section
page 71.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 79 (rack server) or
server).
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
Ê Remove the air duct as described in section
on page 100.
Ê Remove the system fan holder as described in section
system fan holder" on page
TX300 S7 / RX350 S7
141.
72.
"Extending the server out of the rack" on page
"Removing the side cover" on page 88
79.
389.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Disabling BitLocker
"Shutting down the server" on
"Disconnecting the server
77.
"Removing the top cover"
"Removing the system air duct"
76.
(tower
"Removing the
331