Ê Remove the system fan holder as described in section
system fan holder" on page
7.4.2.3
Removing accessible drive dummy covers
Removing accessible drive filler covers
Figure 191: Removing an accessible drive filler cover
Ê Hold the accessible drive filler cover by its two handle recesses and pull it
out of the desired installation bays.
V
CAUTION!
Always replace filler covers into unused drive bays to comply with
applicable EMC regulations and satisfy cooling requirements.
TX300 S7 / RX350 S7
389.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Removing the
313