Preparation
9
Preparation
9
Inserting the needle
.01
Fig. 9 - 01
9 - 1
All regulations and instructions in this Instruction Manual are to be observed!
Special attention is to be paid to the safety regulations!
All preparation work is only to be carried out by appropriately trained personnel.
Before all preparation work, the machine is to be separated from the electricity
supply by removing the plug from the mains or switching off the On/Off switch!
Switch off the machine!
Danger of injury by
unintentional starting of the
machine!
Only use needles from the
system intended for the
machine, see Chapter 3
Specifications.
Raise the needle bar to its highest position.
Loosen screw 1.
1
Insert the needle 2 in the needle bar as
far as it will go (The long needle groove
2
must be pointing left – as seen in the
direction of sewing.)
Tighten screw 1.