Clearance Between Presser Foot And Needle Plate - Pfaff 3822-2/42 Instruction Manual

Adjustment
13

Clearance between presser foot and needle plate

.05.08
13 - 10
Requirement
When hand lever 1 is raised there should be a clearance of 5 mm between the presser
foot and the needle plate.
5
9
8
7
4
1
3
Fig. 13 - 08
With the hand lever lower the presser foot onto the needle plate.
Loosen the adjustment screw for the presser foot presser (reduce pressure)
Push out bolt 1 (screw 2) and remove connection element 3 from the yoke of lever 4.
By turning the balance wheel bring lever 5 to its furthest point of reversal.
Place feed dog adjustment gauge under the presser foot with the recess facing down.
Loosen screw 6 and push out bolt 7.
Adjust presser foot (screw 8) at the side so that the edge of the presser foot is parallel to
the bottom feed dog.
Lower lifting piece 9 as far as possible and tighten screw 8.
Screws 2 and 6 remain loosened for further adjustments.
6
2