Preparation; Inserting The Needle - Pfaff 3834-14/11 Instruction Manual

9

Preparation

9

Inserting the needle

.01
1
Fig. 9 - 01
All regulations and instructions in this Instruction Manual are to be observed!
Special attention is to be paid to the safety regulations!
All preparation work is only to be carried out by appropriately trained personnel.
Before all preparation work, the machine is to be separated from the electricity
supply by removing the plug from the mains or switching off the On/Off switch!
2
The selection of the correct needle depends on the model of the machine, as
well as the material and threads being sewn (see chapter 3.02 Model, needle
and thread).
Switch off the machine!
Danger of injury if the machine
is started accidentally!
Only use needles from the
system intended for the
machine, see Chapter 3
Specifications.
● Raise the roller presser 1.
● Pull down roller presser 1 a little and
swing it towards the left.
● Loosen screw 2 and insert the needle as
far as possible. The long needle groove
must be facing towards the left.
● Tighten screw 2 and swing the roller
presser back into position.
Preparation
9 - 1