Table of Contents
Advertisement
Function 34
SERVICE SCHEDULE
MONTH 00/00/2000
34
SERVICE SCHEDULE
10000's 000000
34
Function 35
SERVICE SCHEDULE
DAY 00/00/2000
35
SERVICE SCHEDULE
10000's
000000
35
Function 36
TELEPHONE #
000 000 0000
36
Table 20 - Maintenance Reminder Function Screens
G. Resetting the Maintenance Schedule
When the system control flashes MAINTENANCE REQUIRED,
it is advisable that you call for service. After the service is
performed, reset the schedule for the next required service by
using the following steps.
Press ENTER on the display for 3 seconds. The Menu code
will appear as 000. This does not change. Press ENTER again.
SERVICE SCHEDULE RESET will be displayed. Using the > key
scroll to the selection of year or hours. Press ENTER to reset
the selected Service Schedule. To change a setting, press
ENTER. Press the ^ and v keys to make adjustments. Press
ENTER when reset is complete.
Month
If the date function was selected,
this function programs the month. If
you selected the run hour function,
you will need to program 10,000
hours, if required.
Hours
Allows the user to set the middle
two digits of the amount of run
hours before next service reminder.
Day
Sets the day of next service
reminder.
Hours
Sets the two right digits of the
amount of run hours for the next
service reminder.
Telephone
Allows the user to input a telephone
number that will display when
maintenance is required.
Part 10 - Start-Up Procedures for the Installer
Table 21 - Heating Curve - NOTE: The user can adjust the heat curve
down by lowering the central heating temperature.
A. Boiler Control Status Menu
The boiler control also has the ability to review system status.
To access the status screens, press >. Once the first value is
displayed, press ^ and v to scroll through additional information.
At any point press RESET to exit the status screens.
49
WHL-052 Rev. 4.28.16
Advertisement
Table of Contents
