Aux In Operation - Jensen JTA-470 User Manual

Platter speed adjustments
B)
During playback of a record, observe the appropriate strip of strobe calibration dots
-
using the STROBE TUNER (#7). The Upper row is for 33 RPM, the middle row is for
45 RPM, and the bottom row is for 78 RPM.
If the strobe dots for the speed you are playing appear to be moving to the right, it
-
means the platter is revolving slower than the rated speed. Slide the PITCH
CONTROL (#10) to the " + " direction. If the strobe dots appear to moving to the left, it
means the platter is revolving faster than rated speed. Slide the PITCH CONTROL
(#10) to the " – " direction.
Adjust the PITCH CONTROL (#10) until the strobe dots for the selected speed
-
appear to be stationary without moving left or right.
IMPORTANT: Using the turntable on any other power source other than 120V AC/60Hz
will affect the strobe tuning accuracy.
You can attach other music sources (iPod, MP3 or other digital audio players) through
the AUX IN JACK (#15) to your external player's audio out jack or headphone jack.
1. Use an audio cable (not included) with one 3.5 mm stereo plug on each end of the
cable.
2. Plug one end into the AUX IN JACK (#15) on the JTA-470 and the other end of the
cable into the Line-out Jack or Headphone Jack of your external audio device. The
JTA-470 will switch to AUX mode automatically.
3. Turn on the JTA-470 and the connected it to your home music system.
4. Start playing the device you plugged into the AUX IN JACK (#15).
5. Slowly adjust both the volume controls of your home music system connect to the
JTA-470 and the external device until you reach a comfortable listening level.
Note:
(1). If the line out jack of your external device is connected, then you only need to adjust
the volume control of the your home music system. If the Headphone Jack of your
external device is connected, then you may need to adjust both the volume control of
your external device and the volume control of the connected Hi Fi system to find the
most desirable volume setting.
(2). Once the AUX IN JACK (#15) is plugged, the unit will enter the AUX mode.
Remember to disconnect the connection cable from the JTA-470 after use in order to
be able to listen to the record from the Turntable.
(3). Press the POWER ON/OFF BUTTON (#2) to turn off the JTA-470 when you finish
listening. Don't forget to switch off the power on the connected Hi Fi system and your
external device as well.

AUX IN OPERATION

E-8