Mounting The Accessory Parts; Installing The User's Guide Holder - Konica Minolta bizhub 363 Installation Manual

10. Connect the machine connector to the control
panel.
A0EDIXC010DA
11. Remove the protective sheet.
A0EDIXC011DB
VII. Mounting the accessory parts
1. Attach the supplied seals A and B.
Note:
If you install the finisher (FS-527) or the job sepa-
rator (JS-505) immediately after the installation of
the machine, you do not have to attach the seals
B.
Seal A
Seal B
A1UDIXC044DA
2. Attach the supplied caps A and B.
A1UDIXC045DA
3. Install the spacer supplied with the machine.
Note:
This step may not be performed depending on the
applicable marketing area.
4. Set the panel pen in the pen holder at the control
panel.
VIII. Installing the user's guide holder
Install the user's guide holder.
E-3
IX. Loading the developer
1. Open the right door.
2. Remove the cover shown in the illustration. (One
screw)
Note:
After removing the screw, slightly raise the cover
and pull it toward you.
A1UDIXE034DA
A0P0IXC055DA
3. Disconnect the connector.
A1UDIXC006DA
A1UDIXC058DA
A1UDIXC008DA