Making The Connections - Bush CDVB52 Installation & User's Instructions

User instructions

Making the connections

ANTENNA IN RF cable
HOW DO I CONNECT THE CDVB52 TO MY TV SET?
1: Put the CDVB52 on a firm, level surface with at least
10 centimetres gap around all the sides and close to
the TV you are going to connect it to.
2: Turn off the mains socket your TV is plugged into or
pull the plug out of the socket.
3: Take the antenna coax cable and connect it to the
ANT IN connector on the back panel of the CDVB52.
4: Connect a scart connector at each end (not supplied)
between the SCART-TV socket on the back panel of
the CDVB52 and the Scart socket on your TV, if there
is more than one Scart connector on the TV, look in
your TV instruction manual to check which one you
should use.
5: Plug the mains lead into the mains socket.
6: Plug the TV back into the mains socket.
NOTE: The CDVB52 will not work if you do not have
the scart-to-scart cable connected.
If you have damaged or missing parts,
call the Customer Helpline: 0870 600 3030
Television
TV Scart Cable
VCR Scart Cable
RECORDING FROM THE CDVB52
1: Connect as described to the left.
2: Using a second scart cable connect the SCART-VCR
output on the rear of the CDVB52 to the SCART input
on a VCR or recording device.
RECORD ONE CHANNEL AND WATCH ANOTHER
1: Should you have a TV with a built in decoder you can
watch a different channel to the one you are recording
by adding a coax cable from the LOOP OUT socket
on the rear of the CDVB52 and into the ANTENNA
input on your TV. You can then record the channel
broadcast through the CDVB52 and watch something
else on the TV decoder.
WATCH A CONNECTED VCR
1: Press the VCR button to switch the input to a
connected VCR player. Press again to switch back to
the CDVB52 input.
VIDEO RECORDER
LOOP OUT RF cable
Page 4