Installation; Configuration; Osd Settings; Tv Settings - Bush CDVB52 Installation & User's Instructions

User instructions

Installation

There are two methods of installation as follows:
Auto search:
When selected the AUTO SEARCH function starts
automatically. Any stations found will be added to the
channel list for radio & TV.
NOTE: If your location falls between transmitters,
then you will be requested to select one after the
scan is complete.
Manual search:
The manual search function requires some
knowledge of digital TV or a specific channels
settings.
1: Set the CHANNEL NAME value to the Channel
number you wish to search.
2: Press the ENTER button and wait for the search
to commence. If the display returns back to the
Installation screen immediately then no stations
where found on that Channel number.
3: If stations are found on the Channel number the
channel list will be built until all are found. Then the
display will return to the Installation screen.

Configuration

The configuration menu allows you to alter the default
settings of the CDVB52.

OSD settings

OSD: Use the / buttons to cycle through various
coloured versions of the graphic interface.
OSD Timeout: Sets the duration the On-Screen display
stays visible for when not in use. The default is 6
seconds. Use the / buttons to cycle through the
options 1-6 seconds.
OSD Trans: Controls the translucency of the interface.
Use the / buttons to cycle through the options
10% - 60%.
OSD Language, Audio Language & Subtitle Language:
Use the / buttons to enter the language selection
options. Then use the /
language you require from English, Gaelic or Welsh.
Press the ENTER button to store the setting.

TV settings

Aspect Ratio: This setting controls how the picture fits
the screen depending on the TV used. Press the /
buttons to cycle through 16:9, 4:3LB ( letter box ) or
4:3PS ( Pan & Scan ).
Video Output: Press the / buttons to cycle through
the two options of RGB or CVBS depending on what
signal your TV requires.
Brightness: Use the / buttons to enter the
Brightness level options. Then use the
to select from 0% to 100%. Press ENTER to apply the
brightness level setting.
buttons to select the
/ buttons
Page 10