Table of Contents
Advertisement
Holding down the buttons 5 or 7 will move the digits
on the clock forwards or backwards faster.
Reading the current time fig. 59
To read the current time, press button 4: the time
will appear on the display for about 10 seconds
and warning light 9 will come on at the same time.
Programming the switching on time fig. 60
Activation can be programmed with an advance
of between 1 minute and 24 hours. Three different
activation times may be selected, but only one can be
activated for each pre-heating cycle.
To program the activation time:
❒ press button 6: the symbol 10 or the time set
previously and the number 3 corresponding to the
preselection recalled will light up in the display
for 10 seconds.
fig. 59
IMPORTANT If you wish to recall other preselected
times, press button 6 from time to time within 10
seconds.
– within 10 seconds, press the buttons 5 or 7 to
select the desired switching on time.
IMPORTANT The confirmation that the time has
been memorised is given by:
❒ the disappearance of the switching on time;
❒ the presence of the preselection number 3;
❒ the lighting of the display.
IMPORTANT When the boiler comes on:
❒ the flame warning light 1 switches on in the
display;
❒ the preselection number 3 goes out.
fig. 60
F0N0153
KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
F0N0154
63
Advertisement
Table of Contents
