Kyocera Marvera Basic Manual page 20

<In the bath>
You can use the product in a bathroom.
• Although you can make calls with wet hands, do not immerse the product into
a bathtub. The product is not resistant to high temperatures.
• Do not use the product in a bathroom for an extended period of time. The
product is not moistureproof.
• Do not immerse the product in hot spring water, soap water, detergent water, or
water with bath salts in it. Also, do not use the product underwater. Doing so
may cause a fault.
• Extreme changes in temperature cause condensation. Wait until the product
reaches room temperature before you bring the product from a cold place into
a warm bathroom.
• If condensation occurs inside the display, leave the product at room
temperature for a while until condensation is cleared.
• When viewing 1Seg, place the product on a stable surface.
• Do not splash the product with hot water. The product is not resistant to high
temperatures.
• Do not bring the desktop holder (sold separately) or AC adapter (sold
separately) into a bathroom.
<Poolside>
• Do not immerse or drop in pool water. Do not use under water.
• Pool water contains disinfecting chlorine. If exposed to pool water, immediately
wash off with room temperature tap water*. Do not use a brush.
* Rather weak water flow (less than 6 L/min.)
• When viewing 1Seg, place the product on a stable surface.
<In the kitchen>
You can use the product in the kitchen and other places where water is used.
• Do not splash the product with or immerse it in soap water, detergent water,
seasonings, juices, etc. other than tap water.
• Do not immerse the product in or splash it with boiling water. The product is not
resistant to hot temperatures.
• Do not place the product where it gets extremely hot or cold such as near a
stove or in a refrigerator.
• When viewing 1Seg, place the product on a stable surface.
18
■ Common precautions
External connection jack cover, back cover
Make sure that the external connection jack cover is firmly closed, and the back
cover is securely attached. Just a small particle (a hair, grain of sand, etc.) on the
seals can cause water leaks.
Do not open/close the external connection jack cover or attach/remove the back
cover with gloved hands. Just a small particle (a hair, grain of sand, etc.) on the
seals can cause water leaks. Wipe off any minuscule droplets of water or dirt with
a clean dry cloth before closing the covers.
If the external connection jack cover or back cover is deteriorated or damaged,
the waterproof property becomes ineffective. In such case, contact an au shop
near you or Secure cell phone support center.
If any liquid other than plain water gets on the product
If any liquid other than plain water (e.g. seawater, detergent, alcohol) gets on the
product, immediately rinse it with plain water.
You can wash the product under a mild flow (up to 6 liters per minute) of tap
water at room temperature (5°C to 35°C) at a distance of about 10 cm from the
faucet or showerhead.
If the product gets dirty, wash it with your hands holding the back cover and
external connection jack cover so that they do not open. Do not use a brush or
sponge.
After the product gets wet
After the product gets wet, drain water, and wipe the product and the back cover
with a clean dry cloth without removing the back cover.
In cold climates, water on the product may turn to frost. Using the product with
frost may cause a fault. Do not leave the product without wiping off water. (No
special measures against condensation have been implemented in this product.)