Installation / Connection; Warning; Caution - Kenwood KDC-X5000BT Instruction Manual

INSTALLATION / CONNECTION

Warning

• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the
car chassis or Ground wire (black) to prevent a short circuit.
• Insulate unconnected wires with vinyl tape to prevent a short circuit.
• Be sure to ground this unit to the car's chassis again after installation.

Caution

• For safety's sake, leave wiring and mounting to professionals. Consult
the car audio dealer.
• Install this unit in the console of your vehicle. Do not touch the metal
parts of this unit during and shortly after use of the unit. Metal parts
such as the heat sink and enclosure become hot.
• Do not connect the [ wires of speakers to the car chassis or Ground
wire (black), or connect them in parallel.
• Mount the unit at an angle of less than 30º.
• If your vehicle wiring harness does not have the ignition terminal,
connect Ignition wire (red) to the terminal on the vehicle's fuse box
which provides 12 V DC power supply and is turned on and off by the
ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers,
wipers, etc. on the car are working properly.
• If the fuse blows, first make sure the wires are not touching car's
chassis, then replace the old fuse with one that has the same rating.
Basic procedure
1
Remove the key from the ignition switch, then
disconnect the [ terminal of the car battery.
2
Connect the wires properly.
See Wiring connection. ( 25)
3
Install the unit to your car.
See Installing the unit (in-dash mounting).
Connect the [ terminal of the car battery.
4
5 Press to turn on the power.
6 Detach the faceplate and reset the unit within
5 seconds. ( 3)
24
Installing the unit (in-dash mounting)
Orientate the trim
plate as illustrated
before fitting.
How to remove the unit
1
Detach the faceplate.
2
Fit the catch pin on the extraction keys into the
holes on both sides of the trim plate, then pull it
out.
3
Insert the extraction keys deeply into the slots
on each side, then follow the arrows as shown
on the right.
Part list for installation
(A) Faceplate (B) Trim plate
Do the required
wiring. ( 25)
Hook on the top side
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
(C) Mounting (D) Wiring harness
sleeve
Dashboard of
your car
(E) Extraction
key