Wall-Mounting The Boiler; Removing/Fitting The Front Casing - Vaillant ECOTEC PLUS VU 80 Installation And Maintenance Instructions Manual

4 Installation
4.5

Wall-mounting the boiler

Danger!
a
Risk of death if the load-bearing capacity
of the fixing elements used is insuffi-
cient!
If the fixing elements or wall do not have
sufficient load-bearing capacity, the boiler
can come loose and fall down. This may
also cause leaks in the gas line, which is
potentially fatal.
> When installing the boiler, make sure that
the fixing elements have a sufficient
load-bearing capacity.
> Check if the supplied fixing kit may be
used for the wall.
> Check the quality of the wall.
> If required, use individual stands from
the cascade programme which is availa-
ble as an accessory.
4.3 Wall-mounting the boiler
> Fit the hanging bracket (1) to the wall using the rawl
plugs and screws provided with the unit.
> Hang the boiler (3) on the hanging bracket from above
using the suspension bracket.
16
4.6

Removing/fitting the front casing

4.4 Removing the front casing
Removing the front casing
1
> Undo the screw (1)
> Push in both retaining clips (2) so that the front casing is
released.
> Pull the front casing forwards at the bottom edge.
> Lift the front casing upwards from the bracket.
Fitting the front casing
> Place the front casing on the upper brackets.
> Push the front casing onto the boiler until the retaining
clips (2) on the front casing snap into place. For support,
you can also pull the retaining clips (2) downwards at the
same time.
> Secure the front casing by tightening the screw (1).
ecoTEC plus installation and maintenance instructions 0020134823_01
2
1