Table of Contents
Advertisement
4.5
Requirements for the installation site
▶
Select the installation site so that the pipes can be easily
routed (gas supply, water supply and drain).
▶
Do not install the product above an appliance whose use
may damage the gas-fired instantaneous water heater
(e.g. above a cooker that can emit grease vapours).
▶
Heat-insulate the wall on which you want to install the
product if the wall is made of a combustible material,
such as wood, so that the minimum clearance between
the hot back panel of the product and the wall is complied
with.
▶
Do not install the product in closed rooms.
4.6
Removing the product casing
C
A
0020271943_00 atmoMAG Installation and maintenance instructions
B
4.7
Installing the product casing
A
C
4.8
Wall-mounting the product
1.
Check the load-bearing capacity of the wall.
2.
Note the total weight of the product.
3.
Only use fixing material that is permitted for the wall.
4.
If required, ensure that mounting apparatus on-site has
sufficient load-bearing capacity.
5.
Wall-mount the product as described.
6.
Drill the holes for the fixing screws while taking into
consideration the dimensions.
7.
To secure the product, depending on the installation
site, use wall anchors, hooks, bolts or threaded bolts as
the fixing material.
8.
Use suitable fixing material to install the back wall of the
unit to the wall.
5
Installation
Danger!
Risk of scalding and/or damage due to
incorrect installation leading to escaping
water.
Stresses in supply lines can cause leaks.
▶
Install the supply lines so that they are
free from mechanical stress.
▶
If you use plastic supply lines for the do-
mestic hot and cold water connection,
these must withstand temperatures up
to 95 °C and pressures up to 1.3 MPa
(13 bar).
Installation 5
B
11
Advertisement
Table of Contents
