Requirements For The Installation Site; Wall-Mounting The Product; Removing The Frame From The Product; Installing The Frame - Vaillant miniVED VED H 3/3 Operating Instructions Manual

4.4 Requirements for the
installation site
▶
Select the installation site so that the
pipes can be easily routed (water sup-
ply and drain).
▶
Do not install the product close to stair-
ways or emergency exits.
▶
Install the product in a frost-free room.
▶
Install the product as close as possible
to the draw-off point.
Note
It is not necessary to install an
expansion relief valve.
▶
Only install the product with the water
connections upwards below the sink.
▶
Ensure that the fixing screws for the
front casing can also be accessed after
the installation.

4.5 Wall-mounting the product

1. Check the load-bearing capacity of
the wall.
2. Note the total weight of the product.
3. Only use fixing material that is permit-
ted for the wall.
4. If required, ensure that mounting ap-
paratus on-site has sufficient load-
bearing capacity.
5. Wall-mount the product as described.
18
4.6 Removing the frame from the
product
1
3
1. Loosen the two fixing screws by two
rotations.
2. Use a flat-blade screwdriver to lever
the frame's seal.
3. Carefully tilt the product with the heat-
ing element towards yourself until
you can remove the product from the
frame.

4.7 Installing the frame

1. Guide the power supply cable through
the grommet.
Installation and maintenance instructions 0020323584_00
2
X2