7. Attach the left and right handle bars.
Remove foam pads
Place a wave
from the handle bar
washer on each
axle but leave the
handle bar axle.
rubber rings.
(This is shown in Step 2.1 through 2.4 on page 10 of the Owner's Manual.)
8. Install the front and rear handle bar covers.
(This is shown in Step 2.4 on page 10 of the Owner's Manual.)
10.
Install the inner connecting arm covers.
Place the covers
over the connecting
arms and secure
using two Phillips
head screws and
two sheet metal
screws.
(See Step 4.1 on page 12.)
13. Install the two stabilizer covers.
Place the covers
on the middle
stabilizer bar, and
attach with one
Phillips head
screw per side.
(See Step 4.3 on page 12.)
15. Install the rear incline bar cover (cont.)
(This is shown in Step 4.5 on page 12 of the Owner's Manual.)
17. Install the incline rail front cover.
Place the incline
rail front cover
over the middle
stabilizer tube,
and attach with
four Phillips
screws.
(See Step 4.7 on page 12.)
Slide the handle
bars on to the
appropriate side of
the axle.
Place the front and rear
handle bar covers over
the handle bar and axle,
and attach using four
sheet metal screws per
side.
11. Install the outer connecting arm covers.
(See Step 4.1 on page 12)
14. Install front stabilizer cover.
(See Step 4.4 on page 12.)
Place the rear incline bar
over the rear incline bar
and attach it to the rail
base using four Phillips
head screws.
18. Plug the power cord into the main
frame of the elliptical trainer, and then
plug the power cord into the wall outlet
Attach both handle
bars using two hex
head bolts and flat
washers.
Be careful not to pinch or cut the wires.
9. Connect the handle bars to the connecting arms.
(This is show in Step 3 on page 11 of the Owner's Manual.)
12. Install sliding wheel covers.
Place the covers
over the inner
covers and secure
using two Phillips
head screws and
two sheet metal
screws.
15. Install the rear incline bar cover.
Place the front
stabilizer cover on
the front stabilizer
and attach using
two Phillips head
screws.
16. Install the rear stabilizer cover.
(This is show in Step 4.6 on page 12 of the Owner's Manual.)
.
Connect the wires
Tuck the wires into
on the handle bars
the console mast
to the wires on the
and cover with the
console mast.
rubber grommets.
Align the hole in the rod
end of the connecting
arms with the brackets
on the handle bar, and
attach using a hex head
bolt, flat washer and
nylon nut.
Place the sliding
wheel covers over
the wheels on the
connecting arms
and secure using
two Phillips head
screws per side.
(See Step 4.2 on page 12)
Attach the two
incline cover
brackets to the
incline rail assembly
using four Phillips
head screws.
(See Step 4.5 on page 12.)
Install the rear stabilizer
cover on the rear
stabilizer using four
Phillips head screws.
19. Remove all packing materials.