Special Tools; Special Tools - Toro Groundsmaster 4500-D Service Manual

Special Tools

Order special tools from your Toro distributor. Some
tools may also be available from a local supplier.
Multimeter
The multimeter can test electrical components and cir-
cuits for current (amps), resistance (ohms) or voltage.
Obtain this tool locally.
NOTE: Toro recommends the use of a DIGITAL Volt--
Ohm--Amp multimeter when testing electrical circuits.
The high impedance (internal resistance) of a digital me-
ter in the voltage mode will make sure that excess cur-
rent is not allowed through the meter. This excess
current can cause damage to circuits not designed to
carry it.
Dielectric Lubricant/Sealant
Dielectric lubricant should be used to prevent corrosion
of non--sealed connection terminals. To ensure com-
plete coating of terminals, liberally apply lubricant to
both component and wire harness connector, plug con-
nector to component, unplug connector, reapply lubri-
cant to both surfaces and reconnect harness connector
to component. Connectors should be thoroughly
packed with lubricant for effective results.
Toro Part Number: 107- -0342
Battery Terminal Protector
Aerosol spray that should be used on battery terminals
to reduce corrosion problems. Apply battery terminal
protector after the battery cable has been secured to the
battery terminal.
Toro Part Number: 107- -0392
Electrical System Page 5 - - 6
Figure 4
Figure 5
Figure 6
Groundsmaster 4500--D/4700--D