Hold Mode Selection - Panasonic KX-TA616 Installation Manual

4.2 System Programming

[104] Hold Mode Selection

You can select how to hold a line and transfer a call to another extension with a single line
telephone (SLT), Hold-1, Hold-2 or Hold-3. If the following occurs frequently with an SLT,
select "Hold-2" or "Hold-3".
• Nobody answers when a call is received.
• A busy tone is heard even though nobody is using the outside (CO) line.
If a call is not terminated after going on-hook, the above cases occur. To avoid these
problems, select "Hold-2" or "Hold-3". Every call will be terminated unless 20 is dialed
after flashing the hookswitch in the Hold-2 and Hold-3 modes.
Hold-1: To hold a line or transfer a call, flash the hookswitch.
Hold-2: To hold a line, flash the hookswitch and dial 20. To transfer a call, flash the
Hold-3: To hold a line or transfer a call, flash the hookswitch and dial 20.
1
Default
• Feature Reference
Section 3, Features
Hold
[105] Conference Tone
Enables or disables the confirmation tone before starting or ending a conference call
established by the Conference feature or Executive Busy Override feature.
1
Default
• Feature References
Section 3, Features
Conference (3-party), Conference (5-party), Executive Busy Override
hookswitch.
0 4
NEXT
(Hold-1/Hold-2
Hold-3)
Hold-1
0 5
NEXT
Enable
SELECT STORE
SELECT STORE
(Enable/
Disable)
[104]-[105]
END
END
System Programming
4-15