Adjusting The Airflow Direction - Sanyo SAP-KCRV243GJH Technical & Service Manual

9-7. Adjusting the Airflow Direction

1. Horizontal
CAUTION
2. Vertical
HIGH
ON . I/OFF . O
POWER
1HR.
TEMP.
ECONOMY MODE
ON OFF
FLAP FAN SPEED
A. Sweep function
The flap starts moving up and down to deliver air
over the sweep range.
NOTE
CAUTION
The horizontal airflow can be adjusted by moving the vertical vanes with your hands to
the left or right.
When the humidity is high, the vertical vanes should be in the front position during
the cooling or dehumidifying operation. If the vertical vanes are positioned all of
the way to the right or left, condensation may begin to form around the air vent
and drip down.
The vertical airflow can be adjusted by moving the flap with the remote control unit. Do
not move the flap with your hands. Confirm that the remote control unit has been turned
on. Use the FLAP button to set either the sweep function or one of the six airflow direction
settings.
The flap automatically closes when the unit is off.
During the heating operation, the fan speed will be very low and the flap will be in the
horizontal position (position*) until the air being blown out of the unit begins to warm.
Once the air warms up, the flap position and fan speed change to the settings specified
with the remote control.
Use the FLAP button on the remote control to adjust the position of the flap. If you move
the flap by hand, the factual flap position and the flap position on the remote control
may no longer match. If this should happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will now be normal again.
Do not have the flap pointed down during cooling and drying operation. Condensation
may begin to form around the air vent and drip down.
64
B. Setting the airflow manually
Referring to the above illustration, use the FLAP
button to set the airflow direction within the range
used during the heating, cooling, or dehumidifying
operation.
*
*
SWEEP
*
*
COOL
and
DRY
SWEEP
HEAT
*
*