Yamaha QL5 Reference Manual page 29

GAIN/PATCH window
(1–32, 33–64/ST IN (QL5), ST IN (QL1))
This window displays the head amp settings of the corresponding input channels. Here you
can also use the [TOUCH AND TURN] knob to adjust the selected head amp gain.
2 1
3
1
Parameter select buttons
Switch parameters to view in the window.
• ANALOG GAIN...................... Analog gain
• DIGITAL GAIN ....................... Digital gain
• PATCH ................................... Patch selection
2
GC ALL ON/GC ALL OFF buttons
Switch Gain Compensation on or off for all input channels simultaneously.
3
Channel select button
Selects the channel. You can select multiple channels simultaneously.
 If you press the ANALOG GAIN parameter select button:
2
1 3
4
1
GAIN knob
Indicates the analog gain setting for each channel. Press the knob to select a channel,
and then control the gain value using the [TOUCH AND TURN] knob. If the Gain
Compensation function is turned on, an indicator will appear, showing the position of
the analog gain when the function is turned on.
2
OVER indicator
Lights when a signal at the input port or from the rack output exceeds the full scale level.
This indicator is available only if an input channel is selected.
3
+48V indicator
Indicates the +48V on/off status for each channel.
2 1
4
Ø (Phase) indicator
Indicates the phase setting for each channel.
NOTE
If the input channel is patched to a slot for which the connection to the head amp is not
recognized, the knob
3
will not be displayed.
If the input channel is patched to a rack, the knob
If nothing is patched to the input channel, the knob
"----" .
 If you press the DIGITAL GAIN parameter select button:
1
1
GAIN knob
Indicates the digital gain setting for each channel. Press the knob to select a channel,
and then control the gain value using the [TOUCH AND TURN] knob.
2
OVER indicator
Lights when a signal at the input port or from the rack output exceeds the full scale level.
This indicator is available only if an input channel is selected.
3
Ø (Phase) indicator
Indicates the phase setting for each channel.
 If you press the PATCH parameter select button:
1
PATCH button
Press this button to open the PORT SELECT window, in which you can select an input
port to patch to the channel.
29
1
will be replaced with the slot/port number of the patch destination.
1
will be replaced with the port ID of the rack.
1
will be replaced with a dotted line
2
3
1
Input channels
Reference Manual